Serving Millcreek, UT
Repair and regrout in Millcreek, UT
Cracked tile, failed grout, loose corners, and the leak nobody found yet.
- One place to describe your project
- Independent local installers do the work
- No obligation to hire anyone
Check local availability
Tell us about your tile project. We review each request by hand and, if an independent local installer is available, we put you in touch. Submitting does not guarantee availability.
We do not do the work. Independent local tile installers do, and you contract directly with the one you choose.
Millcreek repair work usually involves tile that someone chose carefully and wants kept. The mid-century brick homes below the canyon mouth around 3300 South and Highland Drive are on their second or third owner, and many carry natural stone in an entry or a master bath. Stone does not clean, cut, or seal the way ceramic does, so the installer identifies the material before touching it. Matching new grout to grout that has sat in daylight for thirty years is a separate problem of its own.
What this covers
- Replacing cracked or broken tiles
- Removing and replacing failed grout
- Resealing corners and changes of plane
- Resetting loose or hollow-sounding tile
- Grout color matching on existing floors
- Assessing whether a repair or a rebuild is the honest answer
What affects the scope
Every tile job is different, and the independent installer who does the work sets their own price. These are the things they will usually need to know before they can estimate:
- How much area is affected, and whether it is one tile or a whole run
- Whether the cause is cosmetic or is movement or water behind the tile
- Whether matching tile still exists, which often decides repair against replace
- How hard the existing grout is to remove without damaging the tile edges
- Whether the substrate underneath is still sound once a tile comes up
- Whether the honest answer is a repair at all, or a rebuild of that area
Worth asking any installer directly: are you licensed and insured for this work, what waterproofing system do you use, what is your estimate and what does it include, when could you start, and what happens if something is not right afterwards? Related reading: What does tile installation actually cost?
Scope and licensing: If the source turns out to be a leaking valve, drain, or supply line, that is licensed plumbing work in Utah and a separate trade from tile. Finding water is common on repair calls, and it changes what the job is. Related reading: Does a tile installer need a license in Utah?
Repair and regrout across Millcreek
Requests come from across the city, from the streets below the mouth of Millcreek Canyon and the neighborhoods around 3300 South and 3900 South, over to the older blocks near Highland Drive and the west side of the city toward State Street.
Questions
Frequently asked
How much does tile repair and regrouting cost in Millcreek?
On the east bench the material usually sets the scope, since natural stone, a honed finish, or an unusual joint width all limit what can be swapped in without the repair reading as a repair. Taylorsville Tile Co. does not set prices. If an independent local installer is available for your job, that installer gives you their own estimate and you agree it directly with them before any work starts.
My Millcreek entry is natural stone, not ceramic. Does that get repaired differently?
Yes, in almost every step. Stone is cut and handled differently, it absorbs, and replacement pieces come out of a different block than the original so the veining and tone will not be identical. Grout color and sealer also change how stone looks once it is wet, which is why a test in an out-of-the-way spot is worth doing before the visible area is touched. A stone repair is judged on how well it disappears, so material selection takes longer than the setting does.
More in Millcreek
Repair and regrout elsewhere
Ready to tell us about your tile project?
Tell us the job and we will check whether an independent local installer is available. No obligation.